8. Well classification

Enter the following well classification information:

Field

Description

Lahee Classification

From the drop-down list, select the well Lahee classification (see Directive 056, Table 7.10).

If the Lahee classification is Deeper Pool Test, well will be exploratory below

From the drop-down list, select the formation below which the proposed well will be exploratory.

Depth (m)

Enter the projected depth (to the nearest metre) to the base of the formation below which the proposed well will be exploratory.

Confidential Status

From the drop-down list, select the confidential status of the proposed well.

If status is Confidential Below, well will be confidential below

From the drop-down list, enter the name of the formation below which the proposed well will be confidential.

Drill cutting samples are required to be taken.

Select Yes to indicate that drill cutting samples are required to be taken (Directive 056, Section 7.10.8 and OGCR, Section 11.010).

Select No to show that the samples are not required.

1a.

If Yes, drill cutting samples will be collected and submitted as required.

Select Yes to show that drill cutting samples will be collected and submitted as required.

Select No to show that the samples will not be collected and submitted. You must attach:

Required Attachment	Description	Type
Drill Cutting Waiver Request	Documentation to support a drill cutting waiver request or a copy of an approval granted by the AER Geology and Reserves group	.doc, .pdf, .jpg

1b.

If required to be collected and submitted, drill cutting samples will be provided as follows

If drill cutting sample collection and submission are ended and then resumed deeper in the well, repeat the following procedure for the next deeper interval in the second row provided.

From Formation	From the drop-down list, select the formation or the casing depth 30 m above which submission of drill cutting samples begins.
Depth	To the nearest metre, enter the proposed depth at which drill cutting sample collection submission begins.
To Formation	From the drop-down list, select the formation or the casing depth 30 m below which sample collection and submission ends or enter total depth if that is where sample collection ends.
Depth	To the nearest metre, enter the proposed depth at which drill cutting sample collection submission ends.